Ranging addon to Primus V4

Home › Forums › Drona Aviation – Drone for Education › Ranging addon to Primus V4

Tagged: ,

Viewing 5 reply threads
  • Author
    Posts
    • March 4, 2021 at 9:10 am #5273
      shally1986
      Participant

        I think u need Primus X flight controller to add the sensors

      • March 4, 2021 at 12:22 pm #5275
        NITIKA JAGGI
        Participant

          Thanks for responding!
          I want to use the ranging sensor with Primus V4 because that is what I have, and I don’t have the funds to buy any other controller. I am sure there will be some way. Maybe soldering the unibus connector will work. My question is whether the firmware will support it or not. How can I make it possible with Primus V4? Could you give me some ideas?

        • March 8, 2021 at 6:39 am #5282
          shally1986
          Participant

            If you see the FC comparison table in the hardware section , the STM processors also look different , so I am not sure sure if the same firmware would work . If you manage to solder unibus you can try flashing Primus x firmware to test .

          • March 12, 2021 at 9:51 am #5301
            NITIKA JAGGI
            Participant

              I hope I can go back to the Primus V4 firmware again if that does not work, right?

            • March 12, 2021 at 8:13 pm #5309
              shally1986
              Participant

                Yes you should be , I read somewhere in the FAQS . BUT have not tried myself

              • March 13, 2021 at 8:10 am #5313
                NITIKA JAGGI
                Participant

                  Ok. Thank you, @shally1986.

              • Author
                Posts
              Viewing 5 reply threads
              • You must be logged in to reply to this topic.