Any Reset options?

Home › Forums › Drona Aviation – Drone for Education › Any Reset options?

Tagged: 

  • This topic has 4 replies, 2 voices, and was last updated 6 years ago by Zore.
Viewing 3 reply threads
  • Author
    Posts
    • November 28, 2018 at 7:14 am #4001
      uniraider
      Participant

        I connected my pluto X drone to the app and I was able to use it. Then I connected to my PC. After a full flash of the AutoTakeOff code from github the drone neither connects to my laptop nor to my android app. What do I do now? Is there a reset firmware that I can run? I have tried switching it on and off.

      • November 28, 2018 at 9:16 am #4002
        Zore
        Participant

          were you able to full flash code successfully? means did you get a message saying “Firmware Flashed Successfully”

        • November 28, 2018 at 9:38 am #4003
          uniraider
          Participant

            @Zore: No, I am not getting any such message.
            On clicking the flash button,
            I get the following image. screenshot
            after which the app goes back to the home page.

            The percentage value does not even increase greater than 10%.
            The app shows connected and the ARM switch turns on, but nothing more happens.

          • November 28, 2018 at 10:35 am #4004
            uniraider
            Participant

              The above screenshot.

              • November 29, 2018 at 5:27 am #4005
                Zore
                Participant

                  SO I think you are not able to flash the firmware.

                  You can Flash firmware through Cygnus and App.

                  Make sure you have updated App and try to flash through app again.

            • Author
              Posts
            Viewing 3 reply threads
            • You must be logged in to reply to this topic.