Forum Replies Created
-
AuthorPosts
-
October 17, 2023 at 11:25 am in reply to: Is it possible for pluto to connect to my home network #15950
You can use our current python package: https://github.com/DronaAviation/Pluto_Drona_Python_Programming
Yes you can connect it to your home network.
You can use telnet commands as mentioned here and set your Pluto WiFi to Mode: 3
Make sure you do not set it to Mode 2.Contact our Tech support at 70660 11808
Contact our Tech support at 70660 11808
Hi Sriharsha
Yes we can help.
Can you contact our support team at 7066011808 and explain the project you are building?Thank you
Can you try this command on command terminal:
codesign –verify –deep –verbose Cygnus.appHi
Please mail us your requirements at support@dronaaviation.com. The team will help you to place order.Are you able to see the battery voltage on your app?
What is the LED sequence you can see?September 2, 2021 at 11:31 am in reply to: What is the purpose of drone_ap_command topic in pluto-ros-package? #5659Hi Maha
AP means access point, ap commands are for WiFi module.Hi Maha Khan
Please check this tutorial to get access of footage.
https://create.dronaaviation.com/software/tutorials/ros/basic-camera-integrationThank you
Hi Ankush,
Yes you can upgrade but upgrade all the four motors.
Please write mail to support@dronaaviation.com with your WiFi SSID.
Hi
There is a 4 pin port at the bottom of flight controller. You need to connect it with the wire connector provided with camera module. When you will switch the drone on, this time you will not see your pluto wifi but camera wifi with name WiFi720xxxxxx. Please connect with it and further steps are same as without camera. IF you see WiFi name something else contact our support at 7066011808 to get the password.You can get all available accessories/addons at https://www.dronaaviation.com/spares/
-
AuthorPosts